Jetour X50 Coolant Guide: 1.5T Petrol

العربية

Quick answer

The X50's 1.5T engine on Jetour UAE's 2027 sheet (1,498 mL, aluminium head, iron block) needs the coolant type Jetour specifies, both to control temperature and to protect the two metals from corrosion. Don't choose coolant by colour, and remember that the X50's engine underguard can hide small leaks. ShipMyPart has not verified the coolant specification, mix, capacity or interval; we confirm by VIN before supplying coolant or cooling parts.

Before you buy coolant for an X50

  • Confirmed by Jetour UAE (2027): 1.5T petrol, 1,498 mL, aluminium head on an iron block.
  • Not published: the engine code and every coolant value.
  • So: the coolant is matched per VIN, and older model years are checked the same way.

Specifications

ItemValueSource
Trim on the MY2027 sheetPremiumwww.jetouruae.com
Engine (MY2027)1.5-litre turbo petrol, in-line 4, 1,498 mLwww.jetouruae.com
Power / torque (MY2027)156 PS (115 kW) / 230 N·mwww.jetouruae.com
Fuel system and engine build (MY2027)Port fuel injection (PFI); aluminium head, iron blockwww.jetouruae.com
Transmission (MY2027)6-speed dual-clutch (6DCT)www.jetouruae.com
Drive (MY2027)Front-wheel drive (FF)www.jetouruae.com

Fluid specifications for this model are confirmed by VIN on request.

The underguard: protection that can hide a leak

The 2027 sheet lists an engine underguard on the X50. It protects the sump and lower engine from stones and kerbs, but it also catches drips. A slow coolant leak from a hose or the water pump can dry on the guard instead of marking the ground, so the first sign may be a falling reservoir level rather than a puddle.

If the level drops, ask the workshop to look on top of the guard and to pressure-test the system.

What the right coolant does

  • Raises the boiling point under pressure so the engine can run hot in summer without boiling.
  • Carries corrosion inhibitors that protect the aluminium head and iron block where they meet.
  • Lubricates the water-pump seal.

Mixing types or topping up with tap water weakens these jobs over time.

A safe weekly look

With the engine cold and the car on level ground, the coolant in the reservoir should sit between MIN and MAX and look clean. Brown colour, oily film or crystals around the cap are reasons to have it checked. Never open the cap on a warm engine.

If the X50 starts to overheat

  1. Switch off the air-conditioning and watch the gauge.
  2. If the warning stays on or the gauge keeps rising, stop somewhere safe and switch off.
  3. Let it cool fully before checking the level; don't add cold coolant to a hot engine.
  4. Have the cause found before driving far: possible causes include a leak, a stuck thermostat, a blocked radiator or a failing water pump.

Which cooling part matches which clue

CluePart a workshop will often check
Wet residue at the front of the engineWater pump or a coolant hose
Gauge rises only in slow trafficRadiator fins blocked, or the cooling fan
Engine slow to warm up, heater lukewarmThermostat stuck open
Crust around a cap or seamExpansion tank or its cap

Ordering coolant for an X50

Send the VIN and tell us if the level has been dropping. If it has, we can quote the coolant together with whichever part your workshop finds at fault, with delivery across the UAE.

Compatible products

Compatibility verification required

No fluid or part is listed here until its specification has been checked against Jetour's requirement for your vehicle. Send your VIN and we will confirm what fits before you order.

Confirm by VIN before you order

Send your VIN (chassis number) and we will confirm the correct coolant for your Jetour X50.

Send VIN on WhatsApp Request a quote

More Jetour X50 maintenance guides

Frequently asked questions

What coolant does the Jetour X50 use?

The type Jetour specifies for the X50's engine. ShipMyPart has not verified it; check the owner's manual or send us your VIN.

Why is my X50 losing coolant without a puddle?

Small leaks can dry on the engine underguard listed on the 2027 sheet. A pressure test and a look on top of the guard usually find them.

Can I mix coolant brands or colours?

Only if both meet the same specification. Colour is not a specification.

Is it safe to drive an overheating X50?

No. Stop safely and switch off; continuing can damage the engine. Have it inspected first.

How much coolant does the X50 hold?

ShipMyPart has not verified the capacity; we confirm it by VIN.

When should X50 coolant be replaced?

Follow the service book or a Jetour service centre. We don't quote an interval until it is verified.

Need parts or fluids for your Jetour X50?

Contact ShipMyPart on WhatsApp or request a quote. We deliver across the UAE.

WhatsApp Request a quote