Geely UAE lists the current Emgrand with a 6-speed automatic (6AT); earlier or imported cars may differ, so confirm the gearbox by VIN. Typical complaints are a delay when selecting D or R, revs flaring between gears, harsh shifts and a gearbox warning. Possible causes include fluid condition, solenoids or the control unit, the torque converter and mounts. Stop safely if drive is lost, and have a qualified workshop read the codes.
Geely UAE lists the current Emgrand sedan with a 6-speed automatic (6AT), paired with the 1.5D petrol engine (90 kW / 120 HP, 152 N·m). Earlier generations or imported cars may have a different transmission, and different gearboxes fail in different ways and use different parts, so confirm the gearbox in your car by VIN before buying anything. This page describes symptoms of a conventional stepped automatic. Fluid type, quantity and service intervals are not verified.
| Item | Value | Source |
|---|---|---|
| Model on the Geely UAE page | Emgrand (sedan) | www.geely.ae |
| Engine | 1.5D petrol, direct injection | www.geely.ae |
| Power / torque | 90 kW (120 HP) / 152 N·m | www.geely.ae |
| Transmission | 6-speed automatic (6AT) | www.geely.ae |
Fluid specifications for this model are confirmed by VIN on request.
| Possible cause | How it often shows |
|---|---|
| Low, old or burnt fluid | Delayed engagement, flare between gears, smell of hot fluid |
| Shift solenoids or valve body | Harsh or erratic shifts, specific gear missing, stored codes |
| Control unit or wiring | Sudden limp mode, warning light, shifts normal again after a restart |
| Torque converter | Shudder at light throttle in higher gears, hum that changes with speed |
| Engine and gearbox mounts | Clunk when selecting gears or on and off the throttle |
A cause may look likely from symptoms, but none is confirmed until a workshop has tested it.
Major internal damage can mean replacing the automatic gearbox as a unit. A shudder traced to lock-up may involve the torque converter. Electrical or shift-logic faults can point to the transmission control unit within control modules. If the workshop changes the fluid, it may also replace the transmission filter. Knocks may come from the mounts, and selector problems from the shifter assembly. All of these are for the 6AT; if your VIN shows a different gearbox, the parts list changes.
| Situation on your Emgrand | What to do |
|---|---|
| No movement in D or R, red warning, smoke or strong burnt smell | Stop safely and switch off. Arrange recovery; further driving can wreck the gearbox. |
| Amber warning with limp mode | Drive gently and briefly to a qualified workshop for a code read. |
| Flare, harsh shifts or a delay into gear, no warning | Book a diagnosis soon: fluid check by the correct method, scan, road test, and possibly an adaptation reset. |
| Clunk only when selecting gears | Ask the workshop to inspect the mounts before suspecting the gearbox itself. |
An automatic in a UAE commuter sedan spends a lot of time in hot, slow traffic, which raises fluid temperature and ages it sooner. Emgrands used for ride-hailing or deliveries clock high mileage quickly, often in short urban stints. If your car works that kind of shift, ask the workshop about the severe-use service schedule in your service book.
Because earlier or imported Emgrands may not share the 6AT listed by Geely UAE, the VIN is the first thing we need. Send it with the workshop's fault codes or report, and ShipMyPart confirms which gearbox your Emgrand has, identifies and matches the parts, and quotes them with delivery in the UAE. For fluid notes, see the Geely Emgrand transmission fluid guide.
Compatibility verification required
No part is listed here as compatible until it has been matched to your vehicle. Send your VIN and we will confirm which parts fit before you order.
Send your VIN (chassis number) and we will confirm the correct gearbox parts for your Geely Emgrand.
Geely UAE lists the current Emgrand with a 6-speed automatic (6AT). Earlier or imported cars may differ, so confirm the gearbox by VIN.
Possible causes include low or old fluid, solenoid or valve faults, or the control unit. A workshop can read the codes and check the fluid.
Flare can indicate fluid problems or internal clutch wear in the automatic. Have it checked before it gets worse.
Only gently and for a short distance to a workshop. Stop if drive is lost or a red warning appears.
Yes. Worn engine or gearbox mounts can cause clunks that feel like harsh shifts.
Send ShipMyPart your VIN and the workshop findings; we confirm the gearbox, match the parts and deliver in the UAE.
Contact ShipMyPart on WhatsApp or request a quote. We deliver across the UAE.